Reference

ubsa(4freebsd)

USB support for Belkin serial adapters

NAME

ubsa – USB support for Belkin serial adapters

SYNOPSIS

To compile this driver into the kernel, place the following lines in your kernel configuration file:

device usb device ucom device ubsa

Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

ubsa_load="YES"

DESCRIPTION

The ubsa driver provides support for the USB-to-RS232 Bridge chip used by a variety of serial adapters from Belkin and other vendors.

The device is accessed through the ucom(4) driver which makes it behave like a tty(4).

HARDWARE

The ubsa driver supports the following adapters:

  • AnyData ADU-500A EV-DO modem

  • AnyData ADU-E100A (no EV-DO mode support)

  • Belkin F5U103

  • Belkin F5U120

  • e-Tek Labs Kwik232

  • GoHubs GoCOM232

  • Peracom single port serial adapter

FILES

/dev/ttyU*

for callin ports

/dev/ttyU*.init
/dev/ttyU*.lock

corresponding callin initial-state and lock-state devices

/dev/cuaU*

for callout ports

/dev/cuaU*.init
/dev/cuaU*.lock

corresponding callout initial-state and lock-state devices

SEE ALSO

tty(4), ucom(4), usb(4)

HISTORY

The ubsa driver appeared in FreeBSD 5.0. The uplcom(4) manual page was adopted from NetBSD by Tom Rhodes ⟨[email protected]⟩ in April 2002 and modified for the ubsa driver by Alexander Kabaev ⟨[email protected]⟩ in October 2002.

AUTHORS

The ubsa driver was written by Alexander Kabaev ⟨[email protected]⟩.

History