NAME
bcm283x_pwm – bcm283x_pwm - driver for Raspberry Pi 2/3 PWM
SYNOPSIS
kldload bcm283x_clkman kldload bcm283x_pwm
DESCRIPTION
The bcm283x_pwm driver provides access to the PWM engine on GPIO12 of Raspberry Pi 2 and 3 hardware.
The PWM hardware is controlled via the sysctl(8) interface:
dev.pwm.0.mode: 1 dev.pwm.0.mode2: 1 dev.pwm.0.freq: 125000000 dev.pwm.0.ratio: 2500 dev.pwm.0.ratio2: 2500 dev.pwm.0.period: 10000 dev.pwm.0.period2: 10000 dev.pwm.0.pwm_freq: 12500 dev.pwm.0.pwm_freq2: 12500
- dev.pwm.0.mode, dev.pwm.0.mode2
-
PWM Mode for channels 1 and 2. Three modes exist, 0=off, 1=PWM, 2=N/M. The N/M mode is a first order delta-sigma mode, which makes a quite handy DAC output with a trivial RC lowpass filter.
- dev.pwm.0.freq
-
The input frequency to the PWM hardware in Hz. Applies to both channels 1 and 2. Minimum frequency is 123 kHz, maximum frequency is 125 MHz.
- dev.pwm.0.period, dev.pwm.0.period2
-
The period length in cycles. In PWM mode, the output frequencies will be ( dev.pwm.0.freq / dev.pwm.period ) and ( dev.pwm.0.freq2 / dev.pwm.0.period2 ). In N/M mode this is the 'M'.
- dev.pwm.0.ratio, dev.pwm.0.ratio2
-
The "on" period in cycles for PWM channels 1 and 2. In PWM mode, to get a 25% dutycycle, set this to 25% of dev.pwm.0.period or dev.pwm.0.period2, as appropriate. In N/M mode this is the 'N'.
- dev.pwm.0.pwm_freq, dev.pwm.0.pwm_freq2
-
The calculated PWM output frequencies in PWM mode, for channels 1 and 2.
NOTES
Currently the bcm283x_pwm driver ignores the 'status="disabled"' flag in the DTB, assuming that if you load the driver, you want it to work.
SEE ALSO
HISTORY
The bcm283x_pwm driver first appeared in FreeBSD 12.0.
AUTHORS
The bcm283x_pwm driver and this manual page were written by Poul-Henning Kamp ⟨[email protected]⟩.