ripd.conf(5)

Macros

A macro is defined with a command of the form name=value. The macro name can contain letters, digits, and underscores and cannot be a reserved word (for example, cost). Within unquoted arguments, the string $name is later expanded to value.

For example:

hi="2"
interface em0 {
	cost $hi
}

Global configuration

Global settings concerns the main behaviour of the daemon.

fib-priority prio

Set the routing priority to prio. The default is 40.

fib-update (yes|no) If set to no, do not update the Forwarding Information Base, a.k.a. the kernel routing table. The default is yes.

rdomain tableid

Specifies the routing table ripd(8) should modify. Table 0 is the default table.

[no] redistribute(static|connected| default)

[no] redistribute prefix

[no] redistribute rtlabel label If set to connected, routes to directly attached networks will be announced over RIP. If set to static, static routes will be announced over RIP. If set to default, a default route pointing to this router will be announced over RIP. It is possible to specify a network range with prefix; networks need to be part of that range to be redistributed. Additionally it is possible to redistribute based on route labels using the rtlabel keyword. By default no additional routes will be announced over RIP.

redistribute statements are evaluated in sequential order, from first to last. The first matching rule decides if a route should be redistributed or not. Matching rules starting with no will force the route to be not announced.

split-horizon(simple|poisoned| none) If set to simple, do not redistribute routes to the interface from which they were learned. If set to poisoned, redistribute routes to the interface from which they were learned, by forcing the metric to infinity. Both these behaviours can resolve routing loops when a router goes down. The default is poisoned.

triggered-updates (yes|no) Immediately trigger responses when a route changes. The default is no.

Interfaces configuration

Each interface can have several parameters configured individually, otherwise they are inherited.

interface em0 {
	cost 9
	auth-type none
}
interface ix1

Interface-specific parameters are listed below.

auth-key key

Set the authentication key for simple authentication. Up to 16 characters can be specified.

auth-md key-id key

Set the authentication key-id and key for crypt authentication. The valid range for key-id is 0-255. Up to 16 characters can be specified for key. Multiple keys may be specified.

auth-md-keyid key-id

Configure the key-id to use for crypt authentication. The valid range for key-id is 0-255. The default key-id is 1.

auth-type(none| simple|crypt) Set the authentication type. The default is none. Simple authentication uses a plaintext password, up to 16 characters. Crypt authentication uses an MD5 hash.

cost number

Cost of the network connected through this interface. Values must be between 1 and 16, inclusive.

demote group

Increase the carp(4) demotion counter by 1 on the given interface group, usually carp, when the interface state is going down. The demotion counter will be decreased when the interface state is active again.

passive

Prevent transmission and reception of RIP packets on this interface and advertise all prefixes configured on this interface.