powermust(8)

NAME

powermust ‐ Driver for Mustek PowerMust series UPS equipment

NOTE

This man page only documents the hardware‐specific features of the powermust driver. For information about the core driver, see nutupsdrv(8).

SUPPORTED HARDWARE

The powermust driver is known to work with the following UPSes:

Maxxtro UPS 600VA
Mustek PowerMust 400VA Plus
Mustek PowerMust 600VA Plus
Mustek PowerMust 800VA Pro
Mustek PowerMust 1000VA Plus
Mustek PowerMust 1400VA Plus
Mustek PowerMust 2000VA USB
OnLite AQUA 50
Soyntec Sekury C 500
Soyntec Sekury C 800
Square One Power QP 1000
Tecnoware Easy Power 1200
Trust UPS 1000 Management PW-4105

It is also known to work with various models from Blazer, Energy Sistem and Fenton Technologies. It may also work with similar models from other manufacturers, but they haven't been tested.

EXTRA ARGUMENTS

This driver does not support any extra settings in the ups.conf(5).

UPS COMMANDS

This driver supports some extra commands (see upscmd(8)):

test.battery.start

Perform a (10 second) battery test

shutdown.return

Turn off the load and return when power is back

shutdown.stayoff

Turn off the load and remain off

shutdown.stop

Stop a shutdown in progress

load.on

Turn on the load immediately

load.off

Turn off the load immediately

reset.input.minmax

Reset minimum and maximum input voltage status

USER VARIABLES

The behavior of the driver can be controlled by some user definable variables (see upsrw(8)):

ups.delay.shutdown

Interval to wait after shutdown with delay command (seconds)

ups.delay.start

Interval to wait before (re)starting the load (seconds)

BUGS

No known bugs at the moment.

AUTHOR

Carlos Rodrigues <[email protected]>

SEE ALSO