fpga_load8
Xorcom astribank (xpp) firmware tool
Usage
fpga_load [-g]
[-r]
[-v]
-D
{/proc/bus/usb | /dev/bus/usb}
/BUS/DEV
fpga_load [-g]
[-v]
-D
{/proc/bus/usb | /dev/bus/usb}
/BUS/DEV
-I
firmware.hex
[-b
dump.bin]
[-i]
fpga_load -h
Overview
fpga_load loads the FPGA firmware to the Xorcom Astribank device. The syntax resembles that of fxload(8).
Options
-
-b dump.bin -
Before writing firmware, bump the processed binary file to dump.bin.
-
-D DEVICE -
Required. The device to read from/write to. On modern UDEV-based system this is usually /dev/bus/usb/bus_num/device_num, where bus_num and device_num are the first two numbers in the output of lsusb(8). On older systems that use usbfs, it is usually /proc/bus/usb/bus_num/device_num.
-
-r -
Reset the Astribank and renumerate its USB connection to power on product ID.
-
-g -
Dump all eeprom data to standard output.
-
-I fireware_file -
The firmware file to write to the device.
-
-i -
Show information about the firmware file (valid only with
-Ioption). Example:./FPGA_1151.hex: Version=3297 Checksum=58270
In particular, the calculated checksum should match the output of sum(1) on the binary firmware file generated by the
-boption.
-
-v -
Increase verbosity. May be used multiple times.
-
-h -
Displays usage message.
Releases
4 releases since Debian 4.0 (Etch); the text changed 1 time.
-b since Debian 5.0 (Lenny);
-i since Debian 5.0 (Lenny);
-r since Debian 5.0 (Lenny).
-d until Debian 4.0 (Etch).