arrayprobe1
Command line hp (compaq) smartarray status checker
Usage
arrayprobe [-f
device]
[-r]
[-o]
[-i]
Overview
This program is capable of checking the status HP (Compaq) array controllers (devices using the Linux cciss and ida drivers). By default it runs in a non verbose mode that can be used as a nagios check or periodic cron job.
Options
-
-f <device> -
Device to open.
-
-r -
Report (verbose) mode.
-
-o -
Only read new events (since last run, CCISS devices only).
-
-i <host> -
Force ida ioctls. (use with -f if the device is supported by the ida driver)
Status
The output is a single line of information about the worst state found. (If one logical drive is recovering and a second drive is in interim recovery mode. It will only report the failing drive.) The exitcodes can be used to determine the severity. The following exit values are returned:
|
Normal. |
|---|---|
|
Warning. |
|
Critical. |
Releases
Unchanged in 3 releases since Debian 4.0 (Etch).