hconf(4)

NAME

hconf – MS Windows Precision Touchpad configuration driver

SYNOPSIS

To compile this driver into the kernel, place the following lines in your kernel configuration file:

Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

hconf_load="YES"

DESCRIPTION

The hconf driver provides support for generic MS Windows Precision Touchpad configuration collection. It enables the host to configure two different aspects of the device. One allows the host to select input mode, and the other allows the host to be selective in what is reported.

SYSCTL VARIABLES

Next parameters are available as sysctl(8) variables. Debug parameter is available as loader(8) tunable as well.

dev.hconf.*.input_mode

HID device input mode: 0 = mouse, 3 = touchpad.

dev.hconf.*.surface_switch

Enable / disable switch for surface: 1 = on, 0 = off.

dev.hconf.*.buttons_switch

Enable / disable switch for buttons: 1 = on, 0 = off.

hw.hid.hconf.debug

Debug output level, where 0 is debugging disabled and larger values increase debug message verbosity. Default is 0.

SEE ALSO

hms(4), hmt(4)

HISTORY

The hconf driver first appeared in FreeBSD 13.0.

AUTHORS

The hconf driver was written by Vladimir Kondratyev ⟨[email protected]⟩. Switch parameter support was added by Andriy Gapon ⟨[email protected]⟩.