NAME
gnunet-transport – measure and control the transport subsystem
SYNOPSIS
gnunet-transport [-b | --benchmark] [-c FILENAME | --config=FILENAME] [-D | --disconnect] [-e | --events] [-h | --help] [-i | --information] [-L LOGLEVEL | --loglevel=LOGLEVEL] [-l LOGFILE | --logfile=LOGFILE] [-m | --monitor] [-p PEER | --peer=PEER] [-P | --plugins] [-s | --send] [-v | --version] [-V | --verbose]
DESCRIPTION
gnunet-transport is a tool to access various functions of GNUnet's transport subsystem from the command-line. Most of these are not expected to be useful for end-users. gnunet-transport can be used to evaluate the performance of the transports, force a peer to connect to another peer (if possible). Other functions should be added in the near future.
- -b | --benchmark
-
Measure how fast we are receiving data (from all connections). On exit, the data rate will be reported. Runs until aborted with CTRL-C.
- -c FILENAME | --config=FILENAME
-
configuration file to use
- -D | --disconnect
-
Force disconnection from a peer (used in conjunction with -p). Note that you can use the gnunet-ats command-line tool to suggest connects.
- -e | --events
-
Provide information about all connect and disconnect events (continuously).
- -h | --help
-
Print the help page.
- -i | --information
-
Print information about our current connections (once).
- -L LOGLEVEL | --loglevel=LOGLEVEL
-
Change the loglevel. Possible values for LOGLEVEL are ERROR, WARNING, INFO and DEBUG.
- -l LOGFILE | --logfile=LOGFILE
-
Configure logging to write logs to LOGFILE.
- -m | --monitor
-
Print information about our current connections (continuously).
- -p PEER | --peer=PEER
-
The peer identity to connect to or monitor.
- -P | --plugins
-
Monitor session state of transport plugins.
- -s | --send
-
Transmit (dummy) traffic as quickly as possible to the peer specified with the -p option. The rate will still be limited by the quota(s) determined by the peers (ATS subsystem). Will run until CTRL-C is pressed or until the connection to the other peer is disrupted.
- -v | --version
-
Print out the version number.
- -V | --verbose
-
be verbose
SEE ALSO
The full documentation for gnunet is maintained as a Texinfo manual. If the info(1) and gnunet programs are properly installed at your site, the command
info gnunet
should give you access to the complete handbook,
info gnunet-c-tutorial
will give you access to a tutorial for developers.
Depending on your installation, this information is also available in gnunet(7) and gnunet-c-tutorial(7).
BUGS
Report bugs by using https://bugs.gnunet.org or by sending electronic mail to ⟨[email protected]⟩.