---
name: "gnunet-testbed-profiler"
section: "1"
platform: "linux"
package: "gnunet"
version: "0.20.0-7"
release: "Debian 13 (Trixie)"
platforms: ["linux"]
url: "https://new.carta.tech/gnunet-testbed-profiler"
---

# gnunet-testbed-profiler(1)

profiling driver for the testbed

## NAME

**gnunet-testbed-profiler** – profiling driver for the testbed

## SYNOPSIS

**gnunet-testbed-profiler** \[**-c** *FILENAME* \| **--config=***FILENAME*\] \[**-e** *COUNT* \| **--num-errors=***COUNT*\] \[**-H** *FILENAME* \| **--hosts=***FILENAME*\] \[**-h** \| **--help**\] \[**-L** *LOGLEVEL* \| **--loglevel=***LOGLEVEL*\] \[**-l** *LOGFILE* \| **--logfile=***LOGFILE*\] \[**-n** \| **--non-interactive**\] \[**-p** *COUNT* \| **--num-peers=***COUNT*\] \[**-v** \| **--version**\]

## DESCRIPTION

**gnunet-testbed-profiler** is a command line profiling driver for the testbed.

## OPTIONS

- **-c** *FILENAME* \| **--config=***FILENAME*

  Use the configuration file FILENAME.

- **-e** *COUNT* \| **--num-errors=***COUNT*

  Tolerate COUNT number of continuous timeout failures.

- **-H** *FILENAME* \| **--hosts=***FILENAME*

  Name of the file with the login information for the testbed.

- **-h** \| **--help**

  Print short help on options.

- **-L** *LOGLEVEL* \| **--loglevel=***LOGLEVEL*

  Use LOGLEVEL for logging. Valid values are DEBUG, INFO, WARNING and ERROR.

- **-l** *LOGFILE* \| **--logfile=***LOGFILE*

  Configure logging to write logs to LOGFILE.

- **-n** \| **--non-interactive**

  Run profiler in non-interactive mode where upon testbed setup the profiler does not wait for a keystroke but continues to run until a termination signal is received.

- **-p** *COUNT* \| **--num-peers=***COUNT*

  Create COUNT number of peers.

- **-v** \| **--version**

  Print GNUnet version number.

## SEE ALSO

The full documentation for gnunet is maintained as a Texinfo manual. If the [info(1)](/info/1.md) and gnunet programs are properly installed at your site, the command

```
info gnunet
```

should give you access to the complete handbook,

```
info gnunet-c-tutorial
```

will give you access to a tutorial for developers.

Depending on your installation, this information is also available in gnunet(7) and gnunet-c-tutorial(7).

## BUGS

Report bugs by using **https://bugs.gnunet.org** or by sending electronic mail to ⟨*gnunet-developers@gnu.org*⟩.