NAME
gnunet-testbed-profiler – profiling driver for the testbed
SYNOPSIS
gnunet-testbed-profiler [-c FILENAME | --config=FILENAME] [-e COUNT | --num-errors=COUNT] [-H FILENAME | --hosts=FILENAME] [-h | --help] [-L LOGLEVEL | --loglevel=LOGLEVEL] [-l LOGFILE | --logfile=LOGFILE] [-n | --non-interactive] [-p COUNT | --num-peers=COUNT] [-v | --version]
DESCRIPTION
gnunet-testbed-profiler is a command line profiling driver for the testbed.
OPTIONS
- -c FILENAME | --config=FILENAME
-
Use the configuration file FILENAME.
- -e COUNT | --num-errors=COUNT
-
Tolerate COUNT number of continuous timeout failures.
- -H FILENAME | --hosts=FILENAME
-
Name of the file with the login information for the testbed.
- -h | --help
-
Print short help on options.
- -L LOGLEVEL | --loglevel=LOGLEVEL
-
Use LOGLEVEL for logging. Valid values are DEBUG, INFO, WARNING and ERROR.
- -l LOGFILE | --logfile=LOGFILE
-
Configure logging to write logs to LOGFILE.
- -n | --non-interactive
-
Run profiler in non-interactive mode where upon testbed setup the profiler does not wait for a keystroke but continues to run until a termination signal is received.
- -p COUNT | --num-peers=COUNT
-
Create COUNT number of peers.
- -v | --version
-
Print GNUnet version number.
SEE ALSO
The full documentation for gnunet is maintained as a Texinfo manual. If the info(1) and gnunet programs are properly installed at your site, the command
info gnunet
should give you access to the complete handbook,
info gnunet-c-tutorial
will give you access to a tutorial for developers.
Depending on your installation, this information is also available in gnunet(7) and gnunet-c-tutorial(7).
BUGS
Report bugs by using https://bugs.gnunet.org or by sending electronic mail to ⟨[email protected]⟩.