NAME
gnunet-nat-auto – autoconfigure and test NAT traversal
SYNOPSIS
gnunet-nat-auto [-a | --auto] [-c FILENAME | --config=FILENAME] [-S NAME | --section=NAME] [-t | --tcp] [-u | --udp] [-w | --write]
DESCRIPTION
gnunet-nat-auto allows testing various NAT traversal functions, as well as attempting auto-configuration. The options are as follows:
- -a | --auto
-
Attempt auto-configuration for NAT traversal.
- -c FILENAME | --config=FILENAME
-
Use the configuration file FILENAME.
- -S NAME | --section=NAME
-
Name of the configuration section with details about the configuration to test. For example "transport-tcp".
- -t | --tcp
-
Use TCP.
- -u | --udp
-
Use UDP.
- -w | --write
-
Write configuration to configuration file, useful in combination with auto-configuration (-a).
EXAMPLES
Automatic configuration:
# gnunet-nat-auto -aw
Probe and write result to configuration
Test configuration:
# gnunet-nat-auto -t -S transport-tcp
Test TCP configuration
# gnunet-nat-auto -t -S transport-http
Test HTTP configuration
# gnunet-nat-auto -u -S transport-udp
Test UDP configuration
SEE ALSO
gnunet-nat(1), gnunet-transport(1)
The full documentation for gnunet is maintained as a Texinfo manual. If the info(1) and gnunet programs are properly installed at your site, the command
info gnunet
should give you access to the complete handbook,
info gnunet-c-tutorial
will give you access to a tutorial for developers.
Depending on your installation, this information is also available in gnunet(7) and gnunet-c-tutorial(7).
BUGS
Report bugs by using https://bugs.gnunet.org or by sending electronic mail to ⟨[email protected]⟩.