NAME
gnunet-cadet – create or obtain information about CADET tunnels and peers
SYNOPSIS
gnunet-cadet [-C CONNECTION_ID | --connection=CONNECTION_ID] [-d | --dump] [-e | --echo] [-o SHARED_SECRET | --open-port=SHARED_SECRET] [-p PEER_ID | --peer=PEER_ID] [-P | --peers] [-T | --tunnels] [-c FILENAME | --config=FILENAME] [-h | --help] [-l FILENAME | --logfile=FILENAME] [-L LOGLEVEL | --loglevel=LOGLEVEL] [-v | --version] ⟨PEER_ID⟩ ⟨SHARED_SECRET⟩
DESCRIPTION
gnunet-cadet prints information about CADET tunnels and peers. It can also be used for command-line based CADET tunnels using the -o SHARED_SECRET option to open a port on a receiving PEER_ID and using gnunet-cadet ⟨PEER_ID⟩ ⟨SHARED_SECRET⟩ to establish one circuit to that peer from any other peer. The receiving process will only accept one incoming circuit, but several commands using the same -o can be issued to satisfy multiple requests. For one-to-many communication gnunet-social(1) may be better suited, however.
- -C CONNECTION_ID | --connection=CONNECTION_ID
-
Provide information about the connection CONNECTION_ID.
- -d | --dump
-
Dump debug information to stderr.
- -e | --echo
-
Activate echo mode.
- -o SHARED_SECRET | --open-port=SHARED_SECRET
-
Listen for connections using a shared secret, provided as SHARED_SECRET, among sender and recipient.
- -p PEER_ID | --peer=PEER_ID
-
Provide information about the peer PEER_ID.
- -P | --peers
-
Provide information about all (known) peers.
- -T | --tunnels
-
Provide information about all tunnels.
- -c FILENAME | --config=FILENAME
-
Use the configuration file FILENAME.
- -h | --help
-
Print the help page.
- -l FILENAME | --logfile=FILENAME
-
Configure logging to write logs to FILENAME.
- -L LOGLEVEL | --loglevel=LOGLEVEL
-
Use LOGLEVEL for logging. Valid values are DEBUG, INFO, WARNING and ERROR.
- -v | --version
-
Print the GNUnet version number.
SEE ALSO
The full documentation for gnunet is maintained as a Texinfo manual. If the info(1) and gnunet programs are properly installed at your site, the command
info gnunet
should give you access to the complete handbook,
info gnunet-c-tutorial
will give you access to a tutorial for developers.
Depending on your installation, this information is also available in gnunet(7) and gnunet-c-tutorial(7).
BUGS
Report bugs by using https://bugs.gnunet.org or by sending electronic mail to ⟨[email protected]⟩.