NAME
gnunet-ats – display information about transport resource allocation
SYNOPSIS
gnunet-ats [-a | --all] [-C PEERID | --connect=PEERID] [-c FILENAME | --config=FILENAME] [-h | --help] [-i PEERID | --id=PEERID] [-k VALUE | --value=VALUE] [-L LOGLEVEL | --loglevel=LOGLEVEL] [-m | --monitor] [-n | --numeric] [-p PREFERENCE | --preference=PREFERENCE] [-q | --quotas] [-t TYPE | --type=TYPE] [-u | --used] [-V | --verbose] [-v | --version]
DESCRIPTION
gnunet-ats can be used to display information about the GNUnet's transport selection mechanism. It shows information about the addresses and the assigned input and output bandwidth.
OPTIONS
- -a | --all
-
List all addresses currently known to ats.
- -C PEERID | --connect=PEERID
-
Ask ATS to suggest an address for PEERID to transport to establish a connection. Note that you can use the gnunet-transport(1) commandline tool to force disconnects.
- -c FILENAME | --config=FILENAME
-
Use the configuration file FILENAME.
- -h | --help
-
Print short help on options.
- -i PEERID | --id=PEERID
-
Print information for a specific peer identity only.
- -k VALUE | --value=VALUE
-
Value to set for when changing preference values.
- -L LOGLEVEL | --loglevel=LOGLEVEL
-
Use LOGLEVEL for logging. Valid values are DEBUG, INFO, WARNING and ERROR.
- -m | --monitor
-
Monitor changes to the bandwidth assignments continuously.
- -n | --numeric
-
Do not resolve IP addresses to hostnames.
- -p PREFERENCE | --preference=PREFERENCE
-
Set preference values, -i, -k and -t required.
- -q | --quotas
-
Print quotas for all network types
- -t TYPE | --type=TYPE
-
Preference type to change: latency | bandwidth
- -u | --used
-
Print addresses actively used only
- -V | --verbose
-
Print verbose output (include ATS address properties)
- v | -version
-
Print GNUnet version number.
SEE ALSO
The full documentation for gnunet is maintained as a Texinfo manual. If the info(1) and gnunet programs are properly installed at your site, the command
info gnunet
should give you access to the complete handbook,
info gnunet-c-tutorial
will give you access to a tutorial for developers.
Depending on your installation, this information is also available in gnunet(7) and gnunet-c-tutorial(7).
BUGS
Report bugs by using https://bugs.gnunet.org or by sending electronic mail to ⟨[email protected]⟩.