dvmrpd.conf(5)

Macros

A macro is defined with a command of the form name=value. The macro name can contain letters, digits, and underscores and cannot be a reserved word (for example, area, interface, or hello-interval). Within unquoted arguments, the string $name is later expanded to value.

For example:

hi="60"
group {
	interface em0 {
		query-interval $hi
	}
}

The same can be accomplished by specifying the query-interval globally or within the group declaration.

Global configuration

All interface related settings can be configured globally, per group and per interface. The only settings that can be set globally and not overruled are listed below.

mfc-update (yes|no) If set to yes, the kernel Multicast Forwarding Cache is updated with information from the daemon. The default is yes.

Groups

Groups can be used to easily configure similar interfaces. All interface-specific parameters can be configured per group, overruling the global settings.

group

Specify a group section, grouping one or more interfaces.

group {
	robustness 4
	interface em0
	interface em1
}

Interfaces

Each interface can have several parameters configured individually, otherwise they are inherited.

interface em0 {
}

Interface-specific parameters are listed below.

igmp-version number

Do not use a newer version than specified. Valid range 1–2. The default version used is 2.

last-member-query-count count

The default value is equal to the default robustness variable; valid range is 1–255.

last-member-query-interval seconds

The default value is 10; valid range is 1–65535.

metric cost

Set the interface metric a.k.a. cost. The default value is 1; valid range is 1–31.

passive

Prevent transmission and reception of IGMP and DVMRP packets on this interface.

query-interval seconds

Set the query interval. The default value is 125 seconds; valid range is 1–65535 seconds.

query-response-interval seconds

Set the query-response-interval; note that this must be less than the query-interval. The default value is 100 seconds; valid range is 1–65535 seconds.

robustness factor

Set the robustness factor; note that this value might have an impact on other variables. The default value is 2; valid range is 1–4.

startup-query-count count

Set the startup-query-interval, used during startup to speed up the process of building the IGMP table for an interface. The default value is equal to the default robustness variable; valid range is the same as the robustness variable.

startup-query-interval seconds

Used during startup, see the startup-query-interval. The default value is query-interval / 4; valid range is the same as the query-interval.