cy(4) on openbsd

NAME

cy – Cyclades Cyclom-{4, 8, 16}Y asynchronous comms board device driver

SYNOPSIS

cy0 at isa? iomem 0xd4000 irq 12 cy* at pci?

DESCRIPTION

This driver provides an interface to Cyclades Cyclom-4Y, Cyclom-8Y and Cyclom-16Y asynchronous multiport serial boards. These boards are based around Cirrus Logic CD1400 communication controllers.

The device minor numbers for this driver are encoded as follows:

    d c c u u u u u	- bits in the minor device number
    bits    meaning
    ----    -------
    uuuuu   physical serial line (i.e., unit) to use
		0-7 on a cyclom-8Y, 0-15 on a cyclom-16Y
    cc      card number
    d       dial-out flag

DIAGNOSTICS

cy0: port 0 ibuf overrun: Incoming characters have been discarded due to a buffer overflow.
cy0: port 0 fifo overrun: Incoming characters have been discarded due to a CD1400 channel overrun. This is caused by interrupts not being serviced sufficiently quickly to prevent the 12 byte receive FIFO on a serial channel from overflowing. Reducing the value of the RX_FIFO_THRESHOLD #define from 6 to something smaller may help slow machines avoid this problem.

HISTORY

Some ideas for the architecture of this driver's two-layer processing model were derived from the fas 2.10 driver by Uwe Doering ⟨[email protected]⟩ and the high-performance com driver by Bruce Evans ⟨[email protected]⟩.

This work was made possible through the donation of a Cyclom-8Y board by the manufacturer, Cyclades Corporation. However, neither Cyclades nor the author make any warranties regarding this software, nor guarantees of support.

AUTHORS

The driver was written by Andrew Herbert ⟨[email protected]⟩.

BUGS

There is currently no BREAK handling - breaks are ignored. There is no support for bad-character reporting, except via PARMRK. The Cyclom-[48]Y boards do not listen to the RTS signal for receiver flow control. FIFO overruns are only logged when the termios IGNPAR setting is enabled.

cy(4)