---
name: "cxl-disable-port"
section: "1"
platform: "linux"
package: "ndctl"
version: "85-1"
release: "Arch Linux 2026-11-01"
platforms: ["linux"]
url: "https://new.carta.tech/cxl-disable-port"
---

# cxl-disable-port(1)

disable / hot-remove a given CXL port and descendants

## NAME

cxl-disable-port - disable / hot-remove a given CXL port and descendants

## SYNOPSIS

```
cxl disable-port <port0> [<port1>..<portN>] [<options>]
```

For test and debug scenarios, disable a CXL port and any memory devices dependent on this port being active for CXL.mem operation.

Given any enable or disable command, if the operation is a no-op due to the current state of a target (i.e. already enabled or disabled), it is still considered successful when executed even if no actual operation is performed. The target can be a bus, decoder, memdev, or region. The operation will still succeed, and report the number of bus/decoder/memdev/region operated on, even if the operation is a no-op.

## OPTIONS

- \-e, --endpoint

  Toggle from treating the port arguments as Switch Port identifiers to Endpoint Port identifiers.

- \-f, --force

  DANGEROUS: Override the safety measure that blocks attempts to disable a port if the tool determines a descendent memdev is in active usage. Recall that CXL memory ranges might have been established by platform firmware and disabling an active device is akin to force removing memory from a running system.

- \--debug

  Turn on additional debug messages including library debug.

## COPYRIGHT

Copyright © 2016 - 2022, Intel Corporation. License GPLv2: GNU GPL version 2  \<http://gnu.org/licenses/gpl.html\>. This is free software: you are free to change and redistribute it.  There is NO WARRANTY, to the extent permitted by law.

## SEE ALSO

[cxl-disable-port(1)](/cxl-disable-port/1.md)