NAME
atlantic-setup - Setup program for ethernet cards based on AT/LANTIC DP83905 chips.
SYNOPSIS
atlantic-setup [options]
DESCRIPTION
atlantic-setup is a setup and diagnostic program for ISA NE2000 Ethernet adapters. It has specific support for configuring the National Semiconductor AT/LANTIC DP83905 used in on ISA Ethernet adapters such as the NE2000plus. It also works several work-alike chips from other vendors.
OPTIONS
These programs follow the usual GNU command line syntax, with long options starting with two dashes (`-'). A summary of options is included below.
- -h, --help
-
Show summary of options.
- -V, --version
-
Show version of program.
- -v, --verbose
-
Verbose mode.
- -q, --quiet
-
Be very unverbose.
- -a, --all
-
Print all registers.
- -N, --NE2000
-
Set card to NE2000 mode.
- -W, --wd8013
-
Set card to WD8013 mode.
- -p, --base-address <port>
-
Specify port to use. Valid values are: 0x240, 0x280, 0x300, 0x320, 0x340, 0x360 (default: 0x300).
- -P, --new_ioport <port>
-
Set card to use new port. Valid values are: 0x240, 0x280, 0x300, 0x320, 0x340, 0x360 (default: 0x300).
- -F, --interface <interface>
-
Interface number. Valid Options are: 10baseT, 10base2, 10base5, AUI.
- -Q, -i, --irq <irq>
-
Specify new interrupt. Valid values are: 3-5,9-12,15.
- -w, --write-EEPROM <values>
-
Write to the EEPROMS with the specified values.
SEE ALSO
AUTHOR
This manual page was written by Alain Schroeder <[email protected]>, for the Debian GNU/Linux system (but may be used by others).