NAME
arrayprobe - command line HP (Compaq) SmartArray status checker
SYNTAX
arrayprobe [-f device] [-r] [-o] [-i]
DESCRIPTION
This program is capable of checking the status HP (Compaq) array controllers (devices using the Linux cciss and ida drivers). By default it runs in a non verbose mode that can be used as a nagios check or periodic cron job.
OPTIONS
- -f <device>
-
Device to open.
- -r
-
Report (verbose) mode.
- -o
-
Only read new events (since last run, CCISS devices only).
- -i <host>
-
Force ida ioctls. (use with -f if the device is supported by the ida driver)
STATUS
The output is a single line of information about the worst state found. (If one logical drive is recovering and a second drive is in interim recovery mode. It will only report the failing drive.) The exitcodes can be used to determine the severity. The following exit values are returned:
- 0
-
Normal.
- 1
-
Warning.
- 2
-
Critical.
BUGS
- None known.
AUTHORS
Hugo Trippaers <[email protected]>