---
name: "Config::Model::models::LCDd::serialVFD"
section: "3pm"
platform: "linux"
package: "libconfig-model-lcdproc-perl"
version: "2.055-2"
release: "Debian 13 (Trixie)"
platforms: ["linux"]
url: "https://new.carta.tech/Config::Model::models::LCDd::serialVFD"
---

# Config::Model::models::LCDd::serialVFD(3pm)

Configuration class LCDd::serialVFD

## NAME

Config::Model::models::LCDd::serialVFD - Configuration class LCDd::serialVFD

## DESCRIPTION

Configuration classes used by Config::Model

generated from LCDd.conf

## Elements

### Brightness

Set the initial brightness  (4 steps 0-250, 251-500, 501-750, 751-1000)  *Optional. Type integer.*

- upstream\_default value :

  1000

### Device

Device to use in serial mode. Usual values are /dev/ttyS0 and /dev/ttyS1.  *Optional. Type uniline.*

- default value :

  /dev/ttyS1

### ISO\_8859\_1

enable ISO 8859 1 compatibility  *Optional. Type boolean.*

- upstream\_default value :

  yes

### OffBrightness

Set the initial off-brightness  This value is used when the display is normally switched off in case LCDd is inactive (4 steps 0-250, 251-500, 501-750, 751-1000)  *Optional. Type integer.*

- upstream\_default value :

  0

### Port

Number of Custom-Characters. default is display type dependent Custom-Characters=0 Portaddress where the LPT is. Used in parallel mode only. Usual values are 0x278, 0x378 and 0x3BC.  *Optional. Type uniline.*

- default value :

  0x378

### PortWait

Set parallel port timing delay (us). Used in parallel mode only.  *Optional. Type integer.*

- upstream\_default value :

  2

### Size

Specifies the size of the VFD.  *Optional. Type uniline.*

- default value :

  20x2

### Speed

set the serial port speed  *Optional. Type enum. choice: '1200', '2400', '9600', '19200', '115200'.*

- upstream\_default value :

  9600

### Type

Specifies the displaytype. 0 NEC (FIPC8367 based) VFDs. 1 KD Rev 2.1. 2 Noritake VFDs (\*). 3 Futaba VFDs 4 IEE S03601-95B 5 IEE S03601-96-080 (\*) 6 Futaba NA202SD08FA (allmost IEE compatible) 7 Samsung 20S207DA4 and 20S207DA6 8 Nixdorf BA6x / VT100 (\* most should work, not tested yet.)  *Optional. Type uniline.*

- upstream\_default value :

  0

### use\_parallel

"no" if display connected serial, "yes" if connected parallel.  I.e. serial by default.  *Optional. Type uniline.*

- upstream\_default value :

  no

## SEE ALSO

- •

  cme